Renesas RZ/A3UL SMARC EVK

From SEGGER Wiki
Revision as of 10:52, 11 August 2022 by Erik (talk | contribs) (→‎Preparing for J-Link)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Renesas RZ/A3UL SMARC evaluation board. The board supports different boot / power modes.

Renesas RZ A3UL SMARC EVK.jpg

Minimum requirements

  • J-Link software V7.70a or later

Preparing for J-Link

  • Make sure that SW1-1 == OFF (default is ON). This is necessary to enable debugging.
  • Connect the J-Link to the SWD header (CN2)
  • Power the board via USB-C (5V / 3A)
  • Press the POWER button for a few seconds until the Carrier PWR On led turns on
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas RZ A3UL SMARC Connect.PNG

Example Project

  • N/A
Retrieved from "https://wiki.segger.com/index.php?title=Renesas_RZ/A3UL_SMARC_EVK&oldid=12698"