From SEGGER Wiki
Revision as of 12:15, 7 June 2021 by Erik (talk | contribs) (SETUP)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Renesas RZ/G2L EVK. A generic startup guide + additional information can be found on Renesas website.

Renesas RZG2L EVK.jpg

Minimum requirements

  • J-Link software V7.22 or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (CN2) on the SMARC module
  • Power the board via CN6 (Power Input)
  • Press the POWER button (SW9) in order to supply the SMARC module with power
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas RZG2L Connect.gif

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas RZ/G2L. It is a simple Hello World sample linked into the internal RAM.