Renesas RZ/T2M-RSK

From SEGGER Wiki
Revision as of 10:24, 30 August 2022 by Erik (talk | contribs) (→‎Example Project)
Jump to: navigation, search

This article describes specifics for the Renesas RZ/T2M-RSK evaluation board.

Renesas RZT2M-RSK.jpg

Minimum requirements

  • J-Link software V7.68 or later

Preparing for J-Link

  • Connect the J-Link to the debug header (J13 or J20)
  • Power the board via USB C (CN5) or external power supply / power jack (CN6)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas RZT2M Connect.PNG

Preperation NOR flash programming

  1. Check whether SW4 on RZ/T2M RSK board is set as 16bit bus boot mode(NOR flash):
    <SW4> (16bit bus boot mode (NOR flash))
    1-OFF; 2-ON; 3-ON; 4-OFF; 5-OFF; 6-ON; 7-OFF; 8-ON; 9-ON; 10-OFF
  2. Push red reset button of RZ/T2M RSK board.


Example Project

TBD

SETUP

TBD

Retrieved from "https://wiki.segger.com/index.php?title=Renesas_RZ/T2M-RSK&oldid=12795"