Difference between revisions of "Secured ST device detected"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "In case of a secured ST device has been detected by the J-Link DLL, the DLL will show up a dialog which gives customers the opportunity to unlock the selected device. This dia...")
 
Line 1: Line 1:
In case of a secured ST device has been detected by the J-Link DLL, the DLL will show up a dialog which gives customers the opportunity to unlock the selected device. This dialog can be suppressed by checking the "Do not show this message again" check box. The selection will be saved in the registry ''HKEY_CURRENT_USER -> Software -> SEGGER -> J-Link -> "DontShowAgainUnlockSTM"''.
+
The J-Link DLL supports auto-detecting of write / read protected STM32 devices. In case of an active protection has been detected, the DLL will show up a dialog which gives customers the opportunity to unlock the selected device. This dialog can be suppressed by checking the "Do not show this message again" check box. The selection will be saved in the registry path below
   
Therefore, customers who want to enable the message box again have to change the registry key "DontShowAgainUnlockSTM" to 0.
+
''HKEY_CURRENT_USER -> Software -> SEGGER -> J-Link -> "DontShowAgainUnlockSTM"''.
  +
  +
To re-enable the message box after suppressing it, can change the registry key "DontShowAgainUnlockSTM" from 1 to 0.
   
   

Revision as of 19:46, 1 February 2016

The J-Link DLL supports auto-detecting of write / read protected STM32 devices. In case of an active protection has been detected, the DLL will show up a dialog which gives customers the opportunity to unlock the selected device. This dialog can be suppressed by checking the "Do not show this message again" check box. The selection will be saved in the registry path below

HKEY_CURRENT_USER -> Software -> SEGGER -> J-Link -> "DontShowAgainUnlockSTM". 

To re-enable the message box after suppressing it, can change the registry key "DontShowAgainUnlockSTM" from 1 to 0.