Starter Kit A34M418VLN v1.2

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the ABOV Starter Kit A34M418VLN v1.2 evaluation board.

ABOV Starter Kit A34M418VLN.jpg

Minimum requirements

  • J-Link software V6.93a or later

Preparing for J-Link

  • Connect the J-Link to the pins as seen in the image/table below:

ABOV Starter Kit A34M418VLN connected.jpg

Cable JTAG-Pin
Red VTref
Blue TMS
Black GND
Yellow TCK
  • Power the board via usb power supply
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ABOV A34M418 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ABOV Starter Kit A34M418VLN v1.2. It is a simple Hello World sample linked into the internal flash.

SETUP