Difference between revisions of "Syntacore SCR1"

From SEGGER Wiki
Jump to: navigation, search
(Embedded Studio)
(Example projects)
Line 18: Line 18:
   
 
'''Note''': Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
 
'''Note''': Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
  +
  +
* [[File:SiFive_ArtyE31_Blinky_Blue_LED.zip]]
   
 
= Available eval boards =
 
= Available eval boards =

Revision as of 17:26, 28 February 2019

The Syntacore SCR1 is a RISC-V based device which is supported by J-Link

J-Link support

Hardware requirements

Please note that a current J-Link model is needed for RISC-V support: Overview

Software requirements

J-Link supports the Syntacore SCR1 since the following J-Link software versions:

Example projects

Embedded Studio

The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @ 0xF0000000

Note: Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.

Available eval boards

The following eval boards are available: