Difference between revisions of "Syntacore SCR1"

From SEGGER Wiki
Jump to: navigation, search
Line 5: Line 5:
 
= J-Link support =
 
= J-Link support =
   
= Hardware requirements =
+
== Hardware requirements ==
 
Please note that a current J-Link model is needed for RISC-V support: [[Software and Hardware Features Overview | Overview]]
 
Please note that a current J-Link model is needed for RISC-V support: [[Software and Hardware Features Overview | Overview]]
   
= Software requirements =
+
== Software requirements ==
 
J-Link supports the Syntacore SCR1 since the following J-Link software versions:
 
J-Link supports the Syntacore SCR1 since the following J-Link software versions:
 
* Release: V6.42g or later ([https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPack Download latest release])
 
* Release: V6.42g or later ([https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPack Download latest release])

Revision as of 16:22, 1 March 2019

The Syntacore SCR1 is a RISC-V based device which is supported by J-Link

J-Link support

Hardware requirements

Please note that a current J-Link model is needed for RISC-V support: Overview

Software requirements

J-Link supports the Syntacore SCR1 since the following J-Link software versions:

Limitations

Maximum JTAG speed

When debugging on the Syntacore SCR1, the max. JTAG speed that can be used is 1/12 of the CPU speed, so usually fJTAG has to be <= 2 MHz. Speeds above this limit will result in unstable operation of the debug interface on the device. The device sometimes simply returns garbage status info and data on debug module accesses. This is not a limitation of J-Link but of the Syntacore SCR1

Example projects

Embedded Studio

The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @ 0xF0000000

Note: Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.

Available eval boards

The following eval boards are available: