Difference between revisions of "Syntacore SCR1"

From SEGGER Wiki
Jump to: navigation, search
(Embedded Studio)
(Example projects)
Line 19: Line 19:
   
 
'''Note''': Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
 
'''Note''': Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
 
 
QSPI flash programming for this device is supported for the following versions:
 
* V6.35g (beta) or later: [https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPackBeta Download latest beta]
 
* V6.36 (release) or later: [https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPack Download latest release]
 
'''Note:''' Currently only programming of the ISSI IS25LQ040B flash (the one mounted on the HiFive IoT board) is supported.
 
   
 
= Available eval boards =
 
= Available eval boards =

Revision as of 17:23, 28 February 2019

The Syntacore SCR1 is a RISC-V based device which is supported by J-Link

J-Link support

Hardware requirements

Please note that a current J-Link model is needed for RISC-V support: Overview

Software requirements

J-Link supports the Syntacore SCR1 since the following J-Link software versions:


Example projects

Embedded Studio

The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @0xF0000000

Note: Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.

Available eval boards

The following eval boards that are based on the FE310 are available:

  • SiFive HiFive1