Difference between revisions of "Syntacore SCR1"
(→Available eval boards) |
|||
| Line 22: | Line 22: | ||
= Available eval boards = |
= Available eval boards = |
||
The following eval boards are available: |
The following eval boards are available: |
||
| − | * [[SCR1 SDK Arty]] |
+ | * [[SCR1 SDK Arty | ARTY board]] |
<references/> |
<references/> |
||
Revision as of 18:24, 28 February 2019
Contents
The Syntacore SCR1 is a RISC-V based device which is supported by J-Link
J-Link support
Hardware requirements
Please note that a current J-Link model is needed for RISC-V support: Overview
Software requirements
J-Link supports the Syntacore SCR1 since the following J-Link software versions:
- Release: V6.42g or later (Download latest release)
- Beta: V6.43d or later (Download latest beta)
Example projects
Embedded Studio
The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @0xF0000000
Note: Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
Available eval boards
The following eval boards are available:
