Difference between revisions of "Syntacore SCR1"

From SEGGER Wiki
Jump to: navigation, search
(Software requirements)
(Embedded Studio)
Line 19: Line 19:
 
The following example project requires [https://www.segger.com/downloads/embedded-studio/ SEGGER Embedded Studio for RISC-V]. It downloads a simple Cnt++ loop into the 64 TCM @ 0xF0000000
 
The following example project requires [https://www.segger.com/downloads/embedded-studio/ SEGGER Embedded Studio for RISC-V]. It downloads a simple Cnt++ loop into the 64 TCM @ 0xF0000000
   
'''Note''': Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
+
* Please make sure to install SEGGER Embedded Studio first
  +
* Then install the J-Link software package
  +
* At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio
  +
* Please perform the update
   
 
* SCR1 on ARTY board: [[File:Syntacore_SCR1_Arty_ES.zip]]
 
* SCR1 on ARTY board: [[File:Syntacore_SCR1_Arty_ES.zip]]

Revision as of 16:19, 28 March 2019

The Syntacore SCR1 is a RISC-V based device which is supported by J-Link

J-Link support

Hardware requirements

Please note that a current J-Link model is needed for RISC-V support: Overview

Software requirements

J-Link software V6.44 or later is required to support the Syntacore SCR1. Older versions will not work.

Limitations

Maximum JTAG speed

When debugging on the Syntacore SCR1, the max. JTAG speed that can be used is 1/12 of the CPU speed, so usually fJTAG has to be <= 2 MHz. Speeds above this limit will result in unstable operation of the debug interface on the device. The device sometimes simply returns garbage status info and data on debug module accesses. This is not a limitation of J-Link but of the Syntacore SCR1

Example projects

Embedded Studio

The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @ 0xF0000000

  • Please make sure to install SEGGER Embedded Studio first
  • Then install the J-Link software package
  • At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio
  • Please perform the update

Available eval boards

The following eval boards are available: