Syntacore SCR1
Contents
The Syntacore SCR1 is a RISC-V based device which is supported by J-Link
J-Link support
Hardware requirements
Please note that a current J-Link model is needed for RISC-V support: Overview
Software requirements
J-Link supports the Syntacore SCR1 since the following J-Link software versions:
- Release: V6.42g or later (Download latest release)
- Beta: V6.43d or later (Download latest beta)
Example projects
Embedded Studio
The following example project requires SEGGER Embedded Studio for RISC-V. It downloads a simple Cnt++ loop into the 64 TCM @0xF0000000
Note: Please make sure to install SEGGER Embedded Studio first and after that the J-Link software package. At the end of the software package installation, you will be asked if you want to update SEGGER Embedded Studio to the latest J-Link SW. Please perform the update.
QSPI flash programming for this device is supported for the following versions:
- V6.35g (beta) or later: Download latest beta
- V6.36 (release) or later: Download latest release
Note: Currently only programming of the ISSI IS25LQ040B flash (the one mounted on the HiFive IoT board) is supported.
Available eval boards
The following eval boards that are based on the FE310 are available:
- SiFive HiFive1