TI LP-EM-CC2340R5

From SEGGER Wiki
Revision as of 14:38, 15 May 2024 by Simon Buchholz (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.
TI LP-EM-CC2340R5.jpg

Preparing for J-Link

  • Connect the J-Link to J4
  • Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

TI CC2340R5 Connect.PNG

Example Project

The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block.

SETUP