TI LP-EM-CC2340R5

From SEGGER Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.
TI LP-EM-CC2340R5.jpg

Preparing for J-Link

  • Connect the J-Link to J4
  • Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

TI CC2340R5 Connect.PNG

Example Project

The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block.

SETUP