TI LP-MSPM0G3507

From SEGGER Wiki
Revision as of 10:06, 16 November 2022 by Fabian (talk | contribs) (Created page with "450px|thumb|right This article describes specifics for the TI LP-MSPM0G3507 evaluation board. It can be used to test & verify MSPM0G device suppo...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
TI LP-MSPM0G3507.jpg

This article describes specifics for the TI LP-MSPM0G3507 evaluation board. It can be used to test & verify MSPM0G device support.

Minimum requirements

  • J-Link software V7.68 or later

Preparing for J-Link

  • Remove all but the first three left jumpers of J101
  • Connect the J-Link to the SWD header (J103)
  • Power the board via the USB jack of the break out board.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:
    TI MSPM0G Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LP-MSPM0G3507. It is a simple Hello World sample linked into the internal flash.

SETUP