TI LP-MSPM0L1306

From SEGGER Wiki
Revision as of 11:08, 16 November 2022 by Fabian (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
TI LP-MSPM0L1306 evaluation board

This article describes specifics for the TI LP-MSPM0L1306 evaluation board. It can be used to test & verify MSPM0L device support.

Minimum requirements

  • J-Link software V7.68 or later

Preparing for J-Link

  • Remove all but the first three left jumpers of J101
  • Connect the J-Link to the SWD header (J103)
  • Power the board via the USB jack of the break out board.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:
    TI MSPM0L Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LP-MSPM0L1306. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=TI_LP-MSPM0L1306&oldid=13422"