The TMS570Lx series features a so called ICEPick which requires a special connect sequence. This sequence is executed by default by the J-Link DLL if the proper device (e.g. TMS570LS3137) is selected. How to select the correct device: https://wiki.segger.com/Selecting_the_correct_device
If a different JTAG-chain is used, a adapted J-Link Script File is required which contains the updated configuration. Please find below two script files for a setup where two TMS570Lx devices are chained in a JTAG-chain (TDI -> TMS570L (#0) -> TMS570L (#1) -> TDO).
RAM initialization on connect
The TMS570Lx device series comes with an ECC protected RAM. To make sure that no ECC errors are generated when reading from the ECC protected RAM region, the J-Link DLL has to initialize this region before reading it in order to make sure that the ECC is valid. Prior the initialization is issued, a reset of the MCU is performed in order to bring the device into a proper state and to make sure that hardware units like for example DMAs are halted during the RAM init. The actual ECC init is performed by using the Memory Hardware Initialization of the MCU.
Whereas this RAM init is required for most setups, there are some setups where this could cause issues (e.g. when attaching to a running session). In order to prevent the J-Link DLL from executing the RAM initialization, an command string must be passed to the J-Link DLL. This can be done by using a J-Link script file. Further information regarding the J-Link script file can be found in the J-Link User Manual (UM08001).
Please note, that the script file has been tested with version V6.12b of the J-Link software and documentation package.
RTT is supported on the TI TMS570Lx device series since J-Link software version V6.82. With older versions RTT will not work.
Tracing on TMS570LC series
This section describes how to get started with trace on the TI TMS570LC MCUs. This section assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001).
Tracing on TI TMS570LC4357
In order to use trace on the TI TMS570LC4357 MCU devices, the following minimum requirements have to be met:
- J-Link software version V6.84a or later
- Ozone V3.20e or later (if streaming trace and / or the sample project from below shall be used)
- J-Trace PRO for Cortex HW version V2.0 or later for streaming trace
The project has been tested with the minimum requirements mentioned above and a custom board. But the project is designed to run on any TMS570LC4357 hardware that has the trace pins connected to the trace header.
Example project: TI_TMS570LC_Trace.zip
The project was tested on custom hardware we received from a customer. Unfortunately there is no eval board available that has the trace pins connected to a trace header. For design guidelines we recommend contacting TI support.