Difference between revisions of "Telink TLSR9518ADK80D"
(Created page with " thumb | right | 500 px | Telink TLSR9518ADK80D evaluation board (TLSR9518 series) The Telink TLSR9518ADK80D is a Telink_TLSR9518|Telink...") |
(→Setting up with J-Link) |
||
| Line 13: | Line 13: | ||
== Setting up with J-Link == |
== Setting up with J-Link == |
||
| − | [[File: |
+ | [[File: Telink_TLSR9518ADK80D_DebugFront.png | thumb | right | 300 px | Telink TLSR9518 series debug interface connection]] |
| + | [[File: Telink_TLSR9518ADK80D_DebugRear.png | thumb | right | 300 px | Telink TLSR9518 series debug interface connection]] |
||
The Telink TLSR9518ADK80D evaluation board comes with an external JTAG debug connector (6 pins: TDI, TDO, TCK, TMS, GND, VBUS). |
The Telink TLSR9518ADK80D evaluation board comes with an external JTAG debug connector (6 pins: TDI, TDO, TCK, TMS, GND, VBUS). |
||
To set the board up with J-Link, the following steps are required: |
To set the board up with J-Link, the following steps are required: |
||
Revision as of 10:29, 20 April 2021
The Telink TLSR9518ADK80D is a Telink TLSR9518 evaluation board.
Features (selection)
- RISC-V 32Bit MCU
- 2MB on board QSPI flash
- Micro USB-B 1.1
- Line-In
- On board LED
- external debug connector pins
For further information please refer to the Telink TLSR9 wiki page
Setting up with J-Link
The Telink TLSR9518ADK80D evaluation board comes with an external JTAG debug connector (6 pins: TDI, TDO, TCK, TMS, GND, VBUS). To set the board up with J-Link, the following steps are required:
-
Connect the J-Link to the evaluation board, using jumper wires as follows at connector J56:
Pin RP Pico Pin J-Link Signal "TL PE4 TDI" 5 TDI "TL PE5 TDO" 13 TDO "TL PE7 TCK" 9 TCK "TL PE6 TMS" 7 TMS "DEBUG" "GND" 4 GND "VBUS" 1 VTref
Note: For a more reliable, simpler solution, the SEGGER Flying Wire Adapter is recommended.
Example Projects
TBD
