Trace board design recommendations
When designing trace boards additional design considerations need to be taken into account to make sure that a clean and noise free signal can propagate from the target device to the trace probe.
The most common recommendations are as follows:
- All trace transmission lines should be as short as possible and have ideally the same length
- Shielded transmission lines can reduce the impact of crosstalk
- Impedance matching of the transmission lines can improve the signal quality drastically
- Serial termination resistors should be considered for long lines transmission lines
- Do not use any capacitive or inductive elements which are connected to the trace lines e.g. diodes, LEDs, capacitors, inductors etc.
- Avoid stubs which create parasitic impedance changes and reflection
- Avoid multi usage of trace pins with other ICs which again will cause unwanted impedance changes and reflection
For design reference our Trace Reference Boards can be used.