Difference between revisions of "Tracing on Infineon XMC4400 series MCUs"
(Created page with "__TOC__ This article describes how to get started with trace on the Infineon XMC4400 series. This article assumes that there is already a basic knowledge about trace in gener...") |
|||
| Line 12: | Line 12: | ||
= Sample project = |
= Sample project = |
||
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
||
| + | |||
| + | [[:File:Infineon_XMC4400-1512_TraceExample.zip | Infineon_XMC4400-1512_TraceExample.zip]] |
||
Revision as of 17:07, 14 February 2017
Contents
This article describes how to get started with trace on the Infineon XMC4400 series. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The Infineon XMC4400 series implements tracing via pins only, so a J-Trace is needed to perform tracing on these devices.
Minimum requirements
In order to use trace on the Infineon XMC4400 series devices, the following minimum requirements have to be met:
- J-Link software version V6.13e (beta) / V6.14 (release) or later
- Ozone V2.22o or later (if streaming trace and / or the sample project from below shall be used)
- J-Trace PRO for Cortex-M HW version V1.0 or later
Sample project
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.
