Difference between revisions of "Tracing on Renesas R7S721001WS (RZ/A1H)"
(Created page with "__TOC__ This article describes how to get started with trace on the Renesas R7S721001WS (RZ/A1H) MCU. This article assumes that there is already a basic knowledge about trace...") |
(→Streaming trace) |
||
| Line 15: | Line 15: | ||
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ''RSK2+RZA1H board''. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ''RSK2+RZA1H board''. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
||
| − | [[Media: |
+ | [[Media:Renesas_RZ_A1H_33MHz_TraceExample_pex.zip | Renesas_RZ_A1H_33MHz_TraceExample.zip]] |
= Tested Hardware = |
= Tested Hardware = |
||
Revision as of 15:31, 14 November 2017
This article describes how to get started with trace on the Renesas R7S721001WS (RZ/A1H) MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The Renesas R7S721001WS (RZ/A1H) MCU implements tracing via pins , so a J-Trace can be used for tracing. ETB tracing is implemented as well and can be used even with a J-Link.
Minimum requirements
In order to use pin trace on the Renesas R7S721001WS (RZ/A1H) devices, the following minimum requirements have to be met:
- J-Link software version V6.20h or later
- Ozone V2.52a or later (if streaming trace and / or the sample project from below shall be used)
- J-Trace PRO for Cortex HW version V1.0 or later
Sample project
Streaming trace
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a RSK2+RZA1H board. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.
Renesas_RZ_A1H_33MHz_TraceExample.zip
