Difference between revisions of "Tracing on Renesas R7S910017 (RZ/T1)"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes how to get started with trace on the Renesas R7S910017 (RZ/T1) MCU. This article assumes that there is already a basic knowledge about trace in...")
 
(Minimum requirements)
Line 8: Line 8:
 
In order to use pin trace on the Renesas R7S910017 (RZ/T1) devices, the following minimum requirements have to be met:
 
In order to use pin trace on the Renesas R7S910017 (RZ/T1) devices, the following minimum requirements have to be met:
 
* J-Link software version V6.20h or later
 
* J-Link software version V6.20h or later
* Ozone V2.52a or later (if streaming trace and / or the sample project from below shall be used)
+
* Ozone V2.52b or later (if streaming trace and / or the sample project from below shall be used)
 
* J-Trace PRO for Cortex HW version V1.0 or later
 
* J-Trace PRO for Cortex HW version V1.0 or later
   

Revision as of 15:35, 14 November 2017

This article describes how to get started with trace on the Renesas R7S910017 (RZ/T1) MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The Renesas R7S910017 (RZ/T1) MCU implements tracing via pins , so a J-Trace can be used for tracing. ETB tracing is implemented as well and can be used even with a J-Link.

Minimum requirements

In order to use pin trace on the Renesas R7S910017 (RZ/T1) devices, the following minimum requirements have to be met:

  • J-Link software version V6.20h or later
  • Ozone V2.52b or later (if streaming trace and / or the sample project from below shall be used)
  • J-Trace PRO for Cortex HW version V1.0 or later

Sample project

Streaming trace

The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a RSK+RZT1 board. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.

Renesas_RZT1_75MHz_TraceExample.zip

Note: The example is shipped with a compiled .JLinkScriptfile, should you need the original source it can be requested at support@segger.com

To create your own .JLinkScriptfile you can use the following project as reference: Tracing on SEGGER_Cortex-M_Trace_Reference_Board


Tested Hardware

RSK+RZT1 board