Difference between revisions of "Tracing on ST STM32F407 (SEGGER Cortex-M Trace Reference Board)"

From SEGGER Wiki
Jump to: navigation, search
(Streaming trace)
(Streaming trace)
Line 14: Line 14:
 
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ''SEGGER Cortex-M Trace Reference Board'' which is part of each J-Trace PRO purchase. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used.
 
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ''SEGGER Cortex-M Trace Reference Board'' which is part of each J-Trace PRO purchase. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used.
   
[[:File:ST_STM32F769I-EVAL_16MHz_Traceexample.zip | ST_STM32F769I-EVAL_16MHz_Traceexample.zip]]
+
[[:File:ST_STM32F407_84MHz_TraceExample.zip | ST_STM32F407_84MHz_TraceExample.zip]]

Revision as of 14:46, 28 February 2017

This article describes how to get started with trace on the ST STM32F769 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The ST STM32F407 MCU implements tracing via pins , so a J-Trace can be used for tracing.

Minimum requirements

In order to use trace on the ST STM32F407MCU devices, the following minimum requirements have to be met:

  • J-Link software version V6.13e (beta) or later
  • Ozone V2.22o or later (if streaming trace and / or the sample project from below shall be used)
  • J-Trace PRO for Cortex-M HW version V1.0 or later

Sample project

Streaming trace

The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a SEGGER Cortex-M Trace Reference Board which is part of each J-Trace PRO purchase. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.

ST_STM32F407_84MHz_TraceExample.zip