Tracing on ST STM32H753

From SEGGER Wiki
Revision as of 11:55, 23 March 2018 by Nino (talk | contribs) (Created page with "This article describes how to get started with trace on the ST STM32H753 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trac...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes how to get started with trace on the ST STM32H753 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The ST STM32H753 MCU implements tracing via pins, so a J-Trace can be used for tracing.

Sample project

The STM32H753 MCU is in regards of tracing comparable to the STM32H743 so the following example projects can be used as reference: https://wiki.segger.com/Tracing_on_ST_STM32H743

Make sure to set the correct device in your Ozone project.