Tracing on Toshiba TMPM370

From SEGGER Wiki
Revision as of 10:10, 9 October 2017 by Nino (talk | contribs)
Jump to: navigation, search

This article describes how to get started with trace on the Toshiba TMPM370 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The Toshiba TMPM370 MCU implements tracing via pins, so a J-Trace can be used for tracing.

Minimum requirements

In order to use streaming trace on the Toshiba TMPM370 MCU devices, the following minimum requirements have to be met:

  • J-Link software version V6.20d or later
  • Ozone V2.46a or later (if streaming trace and / or the sample project from below shall be used)
  • J-Trace PRO for Cortex-M HW version V1.0 or later

Sample project

Streaming trace

The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a TMPM370-SK Evalboard. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.

Toshiba_TMPM370_40MHz_TraceExample.zip

Note: The example is shipped with a compiled .JLinkScriptfile, should you need the original source it can be requested at support@segger.com

To create your own .JLinkScriptfile you can use the following project as reference: Tracing on SEGGER_Cortex-M_Trace_Reference_Board

Tested Hardware

TMPM370-SK