Difference between revisions of "UM08001 J-Link / J-Trace User Guide"
(→J-Link WiFi setup) |
|||
Line 14: | Line 14: | ||
== J-Link WiFi setup == |
== J-Link WiFi setup == |
||
+ | |||
− | TBD |
||
+ | J-Link WiFi can be set up in multiple ways. |
||
+ | |||
+ | 1) Using J-Link Commander: |
||
+ | - Connect J-Link WiFi to your computer via USB |
||
+ | - Start J-Link Commander (JLink.exe) |
||
+ | - Set up the SSID of your wireless network with the following command: SetWifi SSID <your_wifi_ssid> |
||
+ | - Set up the password to your wireleass network with the following command: SetWifi Pass <your_wifi_password> |
||
+ | - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on). |
||
+ | |||
+ | 2) Using J-Link Configurator: |
||
+ | - Connect J-Link WiFi to your computer via USB |
||
+ | - Start J-Link Configurator (JLinkConfig.exe) |
||
+ | - Right-click on the J-Link WiFi in the list of connected J-Links and select 'Configure' |
||
+ | - In the WiFi configuration section, enter the SSID and the password of your wireless network |
||
+ | - Click OK |
||
+ | - Unplug and reconnect your J-Link WiFi |
||
+ | - Click OK |
||
+ | - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on). |
||
== J-Link WiFi in J-Link Configurator == |
== J-Link WiFi in J-Link Configurator == |
Revision as of 16:01, 8 November 2019
Contents
J-Link User Guide
J-Link software and documentation package
JRun
TBD
Command line options
TBD
Working with J-Link and J-Trace
J-Link WiFi setup
J-Link WiFi can be set up in multiple ways.
1) Using J-Link Commander: - Connect J-Link WiFi to your computer via USB - Start J-Link Commander (JLink.exe) - Set up the SSID of your wireless network with the following command: SetWifi SSID <your_wifi_ssid> - Set up the password to your wireleass network with the following command: SetWifi Pass <your_wifi_password> - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on).
2) Using J-Link Configurator: - Connect J-Link WiFi to your computer via USB - Start J-Link Configurator (JLinkConfig.exe) - Right-click on the J-Link WiFi in the list of connected J-Links and select 'Configure' - In the WiFi configuration section, enter the SSID and the password of your wireless network - Click OK - Unplug and reconnect your J-Link WiFi - Click OK - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on).
J-Link WiFi in J-Link Configurator
JLink WiFi will only be shown in the Configurator if connected via USB. This is because the Configurator uses UDP broadcast packets to find J-Links in the network. However, most routers have UDP broadcast and UDP multicast packets disabled for WiFi networks.