UM08001 J-Link / J-Trace User Guide
Contents
J-Link User Guide
J-Link software and documentation package
JRun
TBD
Command line options
TBD
Working with J-Link and J-Trace
J-Link WiFi setup
J-Link WiFi can be set up in multiple ways.
1) Using J-Link Commander: - Connect J-Link WiFi to your computer via USB - Start J-Link Commander (JLink.exe) - Set up the SSID of your wireless network with the following command: SetWifi SSID <your_wifi_ssid> - Set up the password to your wireleass network with the following command: SetWifi Pass <your_wifi_password> - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on).
2) Using J-Link Configurator: - Connect J-Link WiFi to your computer via USB - Start J-Link Configurator (JLinkConfig.exe) - Right-click on the J-Link WiFi in the list of connected J-Links and select 'Configure' - In the WiFi configuration section, enter the SSID and the password of your wireless network - Click OK - Unplug and reconnect your J-Link WiFi - Click OK - After a few seconds, J-Link WiFi should be connected to your wireless network (the green WiFi LED should be always on).
J-Link WiFi in J-Link Configurator
JLink WiFi will only be shown in the Configurator if connected via USB. This is because the Configurator uses UDP broadcast packets to find J-Links in the network. However, most routers have UDP broadcast and UDP multicast packets disabled for WiFi networks.