Difference between revisions of "Using J-Link via WiFi"
(→J-Link PRO and J-Trace PRO (Cortex-M)) |
(→J-Link BASE or higher) |
||
Line 21: | Line 21: | ||
<br clear=all> |
<br clear=all> |
||
− | == J-Link |
+ | == Via J-Link Remote Server == |
[[File:J-Link-BASE-RasPi-Remoteserver.png | thumb | right | 600px | Explanatory picture will follow shortly]] |
[[File:J-Link-BASE-RasPi-Remoteserver.png | thumb | right | 600px | Explanatory picture will follow shortly]] |
||
+ | This way of WiFi-enable is supported by the following models: |
||
− | All other J-Link models do not come with native Ethernet support. |
||
+ | * J-Link BASE |
||
− | '''However, it is still possible to make them accessible via WiFi.''' |
||
+ | * J-Link PLUS |
||
+ | * J-Link ULTRA+ |
||
+ | * J-Link PRO |
||
+ | * J-Trace PRO |
||
The easiest and most commonly used method to do so is by using a Raspberry Pi (RasPi), running the [[J-Link Remote Server]]. |
The easiest and most commonly used method to do so is by using a Raspberry Pi (RasPi), running the [[J-Link Remote Server]]. |
||
# Start the RasPi and connect it to the desired WiFi network. |
# Start the RasPi and connect it to the desired WiFi network. |
Revision as of 18:54, 28 October 2021
This article explains different methods that can be used to connect to a J-Link and debug via WiFi.
J-Link WiFi
The J-Link WiFi comes with native WiFi support.
For detailed information on how to setup the J-Link WiFi, please refer to this article.
Via WiFi bridge
This method is possible with the following models:
- J-Link PRO
- J-Trace PRO
The J-Link PRO and J-Trace PRO models have an Ethernet connector for wired Ethernet. Therefore, making these models accessible via WiFi can be achieved by simply using a WiFi bridge.
- Setup a WiFi bridge for the desired WiFi network.
- Power the J-Link PRO / J-Trace via a 5V USB power supply (e.g. mobile powerbank).
- Connect the WiFi bridge to the Ethernet connector of the J-Link PRO.
Via J-Link Remote Server
This way of WiFi-enable is supported by the following models:
- J-Link BASE
- J-Link PLUS
- J-Link ULTRA+
- J-Link PRO
- J-Trace PRO
The easiest and most commonly used method to do so is by using a Raspberry Pi (RasPi), running the J-Link Remote Server.
- Start the RasPi and connect it to the desired WiFi network.
- Install the J-Link Software Pack on the RasPi and the remote PC (available on the homepage).
- Connect the J-Link to the RasPi via USB.
- Start the J-Link Remote Server on the RasPi and use it to connect to the J-Link.
- Install the J-Link Software Pack on the remote PC that is supposed to connect to the J-Link.
- From the remote PC connect to the J-Link Remote Server on the RasPi as described in the J-Link Remote Server article.
Note:
This method works for all latest J-Link models.
This method works for all latest J-Link models.