ESWIN ECR2560 FULLMASK 40PIN EVK
This article describes specifics for the ECR2560 FULLMASK 40PIN EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J18.
- Power the board via 13.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN ECR2560 FULLMASK 40PIN EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V7.20
- Hardware: ESWIN ECR2560 FULLMASK 40PIN EVK
- Link: File:ESWIN ECR2560 FULLMASK 40PIN EVK ECR2560 TestProject ES 7V20.zip