NXP X-OM2CTN730
This article describes specifics for the NXP X-OM2CTN730 evaluation board.
Preparing for J-Link
- Connect the J-Link to J302
- Power the board via J400.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-OM2CTN730.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92g
- Embedded Studio: V7.20
- Hardware: NXP X-OM2CTN730
- Link: File:NXP X-OM2CTN730 CTN730 TestProject ES 7V20.zip