TI LP-EM-CC2340R5

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.
TI LP-EM-CC2340R5.jpg

Preparing for J-Link

  • Connect the J-Link to J4
  • Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

TI CC2340R5 Connect.PNG

Example Project

The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=TI_LP-EM-CC2340R5&oldid=14955"