Difference between revisions of "Renesas RZ/T2L-RSK"
(Created page with "__TOC__ This article describes specifics for the Renesas RZ/T2L-RSK evaluation board. 450px == Minimum requirements == * J-Link software V7.8...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 13:33, 15 May 2024
Contents
This article describes specifics for the Renesas RZ/T2L-RSK evaluation board.
Minimum requirements
- J-Link software V7.88 or later
Preparing for J-Link
- Connect the J-Link to the debug header (J13 or J20)
- Power the board via USB C (CN5) or external power supply / power jack (CN6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
NOR flash programming
Not supported yet.
Example Project
TBD
SETUP
TBD