Difference between revisions of "TI LP-EW-CC1314R10"
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:14, 8 May 2024
This article describes specifics for the TI Launchpad EW-CC1314R10 evaluation board.
Preparing for J-Link
- Connect the J-Link to Target In
- Power the board via J1.1(3,3V) J3.21(GND)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI Launchpad EW-CC1314R10.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88g
- Embedded Studio: V6.34
- Hardware: TI Launchpad EW-CC1314R10
- Link: File:TI LP-EW CC1314R10 CC1314R10 TestProject ES V634.zip