Difference between revisions of "GigaDevice GD32F310F-START"
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 23: | Line 24: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310F-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7.94k |
||
*Embedded Studio: V7.12a |
*Embedded Studio: V7.12a |
||
*Hardware: GigaDevice GD32F310F-START |
*Hardware: GigaDevice GD32F310F-START |
||
− | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F310F8P6_TestProject_ES_7V12a.zip]] |
Latest revision as of 14:27, 15 May 2024
This article describes specifics for the GigaDevice GD32F310F-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP3 | 1 | +V |
GND | JP3 | 4 | G |
TMS/SWDIO | JP3 | 2 | IO |
TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310F-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32F310F-START
- Link: File:GigaDevice GD32F310F8P6 TestProject ES 7V12a.zip