Difference between revisions of "GigaDevice GD32350R-EVAL"
(→Preparing for J-Link) |
(→Preparing for J-Link) |
||
Line 6: | Line 6: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link to the JTAG header (JP3) |
*Connect the J-Link to the JTAG header (JP3) |
||
− | *Power the board via |
+ | *Power the board via CN1. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:GigaDevice_GD32350R-EVAL_GD32F350RB_connect.png|400px]] |
[[File:GigaDevice_GD32350R-EVAL_GD32F350RB_connect.png|400px]] |
Revision as of 15:21, 2 April 2024
This article describes specifics for the GigaDevice GD32F310C-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP3)
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32350R-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32350R-EVAL
- Link: File:TODO.zip