Difference between revisions of "GigaDevice GD32303C-START"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32303C-START evaluation board.<br> 450px == Prepari...") |
(→SETUP) |
||
Line 25: | Line 25: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32303C-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32303C-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7.94k |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: GigaDevice GD32303C-START |
*Hardware: GigaDevice GD32303C-START |
||
− | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F303CG_TestProject_ES_V810b.zip]] |
Revision as of 14:44, 2 April 2024
This article describes specifics for the GigaDevice GD32303C-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP2 | 17 | +3V3 |
GND | JP2 | 20 | GND |
TMS/SWDIO | JP2 | 4 | PA13 |
TCK/SWCLK | JP2 | 7 | PA14 |
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32303C-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32303C-START
- Link: File:GigaDevice GD32F303CG TestProject ES V810b.zip