Difference between revisions of "NXP 8MPLUSLPD4 EVK"
(Created page with "This article describes specifics for the NXP 8MPLUSLPD4-EVK evaluation board. It can be used to test & verify NXP iMX 8M Plus device support for Cortex-M7. __TOC__ File:NXP_...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
This article describes specifics for the NXP 8MPLUSLPD4-EVK evaluation board. |
This article describes specifics for the NXP 8MPLUSLPD4-EVK evaluation board. |
||
It can be used to test & verify NXP iMX 8M Plus device support for Cortex-M7. |
It can be used to test & verify NXP iMX 8M Plus device support for Cortex-M7. |
Latest revision as of 13:16, 15 May 2024
This article describes specifics for the NXP 8MPLUSLPD4-EVK evaluation board. It can be used to test & verify NXP iMX 8M Plus device support for Cortex-M7.
Minimum requirements
- J-Link software V7.94 or later
- The board should have a bootloader(U-Boot) image on one of the available boot device
Preparing for J-Link
- Connect the J-Link to JTAG connector (J24).
- Connect the onboard USB-UART debug interface to host computer (J23).
- Open a serial interface communication via terminal application(PuTTY).
- Power the board via USB Type-C Power connector (J5).
- Turn on the power switch (SW3).
- Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP 8MPLUSLPD4-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94
- Embedded Studio: V8.10
- Hardware: NXP 8MPLUSLPD4-EVK
- Link: File:NXP 8MPLUSLPD4 EVK M7 TestProject ES 8V10.zip