Difference between revisions of "GigaDevice GD32103E-EVAL"
(13 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
||
− | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg| |
+ | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg|680px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 15: | Line 16: | ||
*Embedded Studio: V8.10b |
*Embedded Studio: V8.10b |
||
*Hardware: GigaDevice GD32103E-EVAL |
*Hardware: GigaDevice GD32103E-EVAL |
||
− | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F103ZE_TestProject_ES_V810b.zip]] |
Latest revision as of 15:54, 31 May 2024
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via CN2.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32103E-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32103E-EVAL
- Link: File:GigaDevice GD32F103ZE TestProject ES V810b.zip