XHSC HC32LF17/9xGO-STK-V2.0
Revision as of 19:12, 17 June 2024 by Torben.scharping (talk | contribs)
This article describes specifics for the XHSC HC32LF17/9xGO-STK-V2.0 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to ......
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | |||
GND | |||
nTRST | |||
TDI | |||
TMS/SWDIO | |||
TCK/SWCLK | |||
RTCK | |||
TDO/SWO | |||
RESET | |||
DBGRQ | |||
5V-Supply |
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the XHSC HC32LF17/9xGO-STK-V2.0.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: XHSC HC32LF17/9xGO-STK-V2.0
- Link: File:XHSC HC32L196PCTA TestProject ES V720.zip