Microchip PIC32CX BZ2

Microchip WBZ450 Curiosity evaluation board

This article describes specifics for the Microchip WBZ450 Curiosity evaluation board. It can be used to test & verify Microchip PIC32CX-BZ2 device support.

Minimum requirements

• J-Link software V7.96m or later

Preparing for J-Link

• Connect the J-Link to the SWD header (J10).
• Power the board via the USB jack of the break out board (J7).
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:
  

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip WBZ450 Curiosity. It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.96m
• Embedded Studio: V8.12a
• Hardware: Microchip WBZ450 Curiosity
• Link: File:Microchip WBZ450 Curiosity TestProject ES 8V12a.zip