GigaDevice GD32A490I-EVAL
Revision as of 08:47, 25 June 2024 by Torben.scharping (talk | contribs)
This article describes specifics for the GigaDevice GD32A490I-EVAL evaluation board.
Minimum requirements
- J-Link software V7.82b or later
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via USB (GD-LINK CN100)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32A490I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96p
- Embedded Studio: V2.20
- Hardware: GigaDevice GD32A490I-EVAL
- Link: File:GigaDevice GD32A490I-EVAL GD32A490ZI TestProject ES 7V20.zip