Difference between revisions of "GigaDevice GD32F527I-EVAL"
| Line 4: | Line 4: | ||
This article describes specifics for the GigaDevice GD32F527I-EVAL evaluation board. |
This article describes specifics for the GigaDevice GD32F527I-EVAL evaluation board. |
||
| − | [[File: |
+ | [[File:GigaDevice_GD32F527I-EVAL_GD32F527IST7_board.jpg|500px]] |
| − | |||
| − | == Minimum requirements == |
||
| − | * J-Link software V7.82b or later |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| Line 23: | Line 20: | ||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: GigaDevice GD32F527I-EVAL |
*Hardware: GigaDevice GD32F527I-EVAL |
||
| − | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F527IST7_TestProject_ES_7V20.zip]] |
Latest revision as of 09:13, 25 June 2024
This article describes specifics for the GigaDevice GD32F527I-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via USB (GD-LINK CN100)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F527I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96p
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32F527I-EVAL
- Link: File:GigaDevice GD32F527IST7 TestProject ES 7V20.zip
