Difference between revisions of "Renesas EK-RA6M4"
(→Preparing for J-Link) |
|||
| Line 2: | Line 2: | ||
This article describes specifics for the Renesas EK-RA6M4 evaluation board.<br> |
This article describes specifics for the Renesas EK-RA6M4 evaluation board.<br> |
||
| − | '''[PICTURE OF BOARD]''' |
||
[[File:Renesas_R7FA6M4AF3_EK-RA6M4_picture.jpg|450px]] |
[[File:Renesas_R7FA6M4AF3_EK-RA6M4_picture.jpg|450px]] |
||
Latest revision as of 15:06, 27 June 2024
This article describes specifics for the Renesas EK-RA6M4 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | J4 | 1 | +3V3 |
| GND | J4 | 39 | GND |
| TMS/SWDIO | J3 | 3 | P108 |
| TCK/SWCLK | J4 | 38 | P300 |
- Power the board via J11.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M4.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Renesas EK-RA6M4
- Link: File:Renesas R7FA6M4F3 TestProject ES V810b.zip
