Renesas EK-RA6M4

From SEGGER Wiki
Revision as of 14:40, 27 June 2024 by Joshua.Kozian (talk | contribs) (→‎Preparing for J-Link)
Jump to: navigation, search

This article describes specifics for the Renesas EK-RA6M4 evaluation board.
[PICTURE OF BOARD] Renesas R7FA6M4AF3 EK-RA6M4 picture.jpg

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref J4 1 +3V3
GND J4 39 GND
TMS/SWDIO J3 3 P108
TCK/SWCLK J4 38 P300
  • Power the board via J11.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas R7FA6M4AF3 EK-RA6M4 connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M4.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Renesas_EK-RA6M4&oldid=20428"