Difference between revisions of "Renesas EK-RA4M2"
(→Preparing for J-Link) |
(→SETUP) |
||
Line 29: | Line 29: | ||
*J-Link software: V8.10b |
*J-Link software: V8.10b |
||
*Hardware: Renesas EK-RA4M2 |
*Hardware: Renesas EK-RA4M2 |
||
− | *Link: [[File: |
+ | *Link: [[File:Renesas_R7FA4M2AD_TestProject_ES_V810b.zip]] |
Latest revision as of 15:59, 28 June 2024
This article describes specifics for the Renesas EK-RA4M2 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J4 | 1 | +3V3 |
GND | J4 | 27 | GND |
TMS/SWDIO | J3 | 3 | P108 |
TCK/SWCLK | J4 | 26 | P300 |
- Power the board via J11.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA4M2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V8.10b
- Hardware: Renesas EK-RA4M2
- Link: File:Renesas R7FA4M2AD TestProject ES V810b.zip