Difference between revisions of "TI LaunchPad CC1354P10"
(Created page with "__TOC__ This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J...") |
(No difference)
|
Revision as of 10:11, 3 February 2023
This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
