Difference between revisions of "Renesas DA1470x DevKit"
(Created page with "__TOC__ This article describes specifics for the Renesas DA1470x DevKit evaluation board.<br> 450px == Preparing for J-Link == *Connect t...") |
|||
Line 9: | Line 9: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:Renesas_DA1470x_DevKit_Connect.PNG|400px]] |
[[File:Renesas_DA1470x_DevKit_Connect.PNG|400px]] |
||
− | |||
− | == Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas DA1470x DevKit.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
− | ====SETUP==== |
||
− | *J-Link software: V7.86b |
||
− | *Embedded Studio: V6.20 |
||
− | *Hardware: Renesas DA1470x DevKit |
||
− | *Link: [[File:Renesas_DA1470x_DevKit_TestProject_ES_V620.zip]] |
Revision as of 12:14, 24 February 2023
Contents
This article describes specifics for the Renesas DA1470x DevKit evaluation board.
Preparing for J-Link
- Connect the J-Link to the 19-pin debug connector (J31).
- Power the board via USB (J8).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows: