Difference between revisions of "ST STM32H573I-DK"
(→Example Project) |
|||
Line 20: | Line 20: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H573I-DK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====Setup==== |
====Setup==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.86c |
− | *Embedded Studio: |
+ | *Embedded Studio: V7.10 |
*Hardware: ST STM32H573I-DK |
*Hardware: ST STM32H573I-DK |
||
*Link: [[File:ST_STM32H573I-DK_HelloWorld.zip]] |
*Link: [[File:ST_STM32H573I-DK_HelloWorld.zip]] |
Revision as of 14:50, 8 March 2023
This article describes specifics for the ST STM32H573I-DK evaluation board.
Preparing for J-Link
- On the back side of the board close jumper J1 so that the board can be accessed with an external debug connector.
- Connect the J-Link to the 10 pin debug connector CN12 which is located on the backside of the board.
- On the display side of the board set jumper JP4 to 3-4 (USB-PD) for power via USB-C (CN17).
- Power the board via USB-C (CN17).
The result should look like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H573I-DK.
It is a simple Hello World sample linked into the internal flash.
Setup
- J-Link software: V7.86c
- Embedded Studio: V7.10
- Hardware: ST STM32H573I-DK
- Link: File:ST STM32H573I-DK HelloWorld.zip