Difference between revisions of "ST NUCLEO-U545R-Q"
(→SETUP) |
(→SETUP) |
||
| Line 17: | Line 17: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: ST STM32U585 |
*Hardware: ST STM32U585 |
||
| − | *Link: [[File: |
+ | *Link: [[File:ST_STM32U545RE_TestProject_ES_V634.zip]] |
Revision as of 13:31, 28 June 2023
This article describes specifics for the ST NUCLEO-U545R-Q evaluation board.
Preparing for J-Link
- Connect the J-Link to CN4.
- Power the board via CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U585.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88j
- Embedded Studio: V6.34
- Hardware: ST STM32U585
- Link: File:ST STM32U545RE TestProject ES V634.zip
