Difference between revisions of "e-peas EDMS105N EVK"
(→SETUP) |
|||
| Line 15: | Line 15: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
| − | *J-Link software: |
+ | *J-Link software: V7.88k |
| − | *Embedded Studio: |
+ | *Embedded Studio: V6.34 |
*Hardware: e-peas EDMS105N_EVK |
*Hardware: e-peas EDMS105N_EVK |
||
| − | *Link: [[File: |
+ | *Link: [[File:Epeas_EDMS105N_TestProject_ES_V634.zip]] |
Revision as of 15:59, 29 June 2023
This article describes specifics for the e-peas EDMS105N_EVK evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88k
- Embedded Studio: V6.34
- Hardware: e-peas EDMS105N_EVK
- Link: File:Epeas EDMS105N TestProject ES V634.zip
