Difference between revisions of "Mindmotion Mini-F5233-MM32F5233D7P"
(→Preparing for J-Link) |
|||
| Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link to the SWD header ( |
+ | *Connect the J-Link to the SWD header (CN1) |
| − | *Power the board via |
+ | *Power the board via USB-C (CN7) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 08:34, 7 September 2023
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
Minimum requirements
- J-Link software V7.92d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN1)
- Power the board via USB-C (CN7)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware: Mindmotion PLUS5270 MM32F5270
- Link: File:MM Mini-F5233 MM32F5233D7P TestProject ES 7V20.zip
